Titan Pinball Kits Database

The Wizard of Oz
Rubber Ring Kit by Scott S.

(1)

Jersey Jack Pinball, Inc. , April, 2013

4 Players

Manual Page Ring Diagram

Description

Easy Install Kit: These are the rings that require no parts or minimal parts removal to install. It also assumes you have a castle mod installed. 
There are only 2 rings you can install in the OZ lanes without any difficulty ( you could use a 90* Phillips screwdriver to change more, if you have one then get 7 rings instead of the 5 I have listed) so I'm only listing those but the picture has more installed.

 I also included pictures of a purple and red 7/16" post rubber installed in the castle playfield so you can see what the colors look like installed in case you wanted to change the orange I have listed.  You could also change the two glow 3/16 ID by the BALL targets  to light blue and I think that would look good or better than the glow. I have a yellow 7/16 OD for in between the 2 main flippers but I don't have a picture of it. I think I like the black better there anyway but you can decide. 

FYI: I used needle nose pliers to remove the 3/8" OD where I couldn't reach in with my fingers. 

One more thing, I used Titans 3/16 ID for the WOZ manuals 3/16 OD. (I think a typo)